Accessing minus parameter in templates

[SilverCorvus]

I stumbled over the problem, that I had to access some of the minus parameters (e.g. -action, -table) in templates, but this wasn't possible the normal way:

Code: Select all

{if $ENV.REQUEST.-table == ...} -- doesn't work.

You can't access it, when the key-value of the array (because it's in fact $ENV['REQUEST']['-table']) doesn't meet the php variable naming conventions. So minus, space, dot ect. doesn't work.

Code: Select all

{if $ENV.REQUEST.`with space` == ...}
{if $ENV.REQUEST."min-us" == ...}
{if $ENV.REQUEST.'with.dot' == ...}

All these scenarios of "bad keys" and tried solutions via escaping don't work.

There are two possible ways:
- Rewrite the array: Probably not so good for Xataface
- A workaround:

Code: Select all

{assign var=_table value="-table"}
{if $ENV.REQUEST.$_table == ...)

In fact it is a Smarty problem, but because of the naming convention of Xataface I thought posting this could help others who stumble over this problem too.

[shannah]

Yes. This is an annoyance, but there are a few solutions in Xataface.

1. Some of the common query parameters have been added directly to the $ENV variable:
- $ENV.action
- $ENV.table
- $ENV.limit
- $ENV.start
- $ENV.mode
- $ENV.search

2. The Dataface_Application class which is accessible from the $ENV variable has a getQueryParam method that allows you to get any query parameter. This takes input parameters without the prefixed dash. e.g. to get the value of $_GET['-action'], you would call $ENV.APPLICATION_OBJECT->getQueryParam('action')

-Steve

[SilverCorvus]

But these directly added parameters are from the query, as you said. But in my special case I would have needed from the request - look at the array to compare:

Code: Select all

[REQUEST] => Array
        (
            [-table] => char
        )
[QUERY] => Array
        (
            [-table] => char
            [-action] => list
            [--original_action] => list
            [-cursor] => 0
            [-skip] => 0
            [-limit] => 30
            [-mode] => list
        )
    [action] => list
    [table] => char

The query/directly added parameters contain also the default value, not the pure request ones.
But there is also your shown way number 2 to accomplish it, if this very special case occurs.